The clever application scheme of special angle hinge and its installation method

 The clever application scheme of special angle hinge and its installation method

What is the hinge, is the cabinet door switch and cabinet connection accessories, the cabinet door is like a hand, the hinge is the joint, a cabinet durable or not, the hinge is very critical.

Conventional hinges is the cabinet square with the door panel, and special hinges, often used in various types of shaped cabinets, such as corner cabinets, refrigerators angled cabinets, pentagonal cabinets, etc., the use of such hinges have various restrictions and disadvantages of the existence.

NO.1 165° hinge and 135° hinge

165° hinges are often used in corner cabinets to achieve large angle opening.

165° hinges require high installation requirements and are prone to the phenomenon of door panels not closing in place, with a small adjustable range. The door seam fastening scale is shown below.

There are three points to note:

1、 need to open the door ① to open the door ②, the same ② to close first;

2、 door plate ① if installed ordinary bouncer, pop-up gap is not enough to finger gouge, it is recommended that the heavy bouncer + 165 ° force-free hinges;;

3、extremely easy to step on the pit event: corner door panel open by the adjacent cabinet door puller top caused by the inability to fully open.

135 ° hinges are commonly used in the linkage door, hinge cup holes hit the outer door position, as follows. If not necessary, it is not recommended to use, close the door is not good to close, not tight, but also easy to produce door sagging phenomenon.

NO.2 90°hinge

Commonly used in corner cabinets, ordinary hinges need to have side panels or in the vertical version can be installed, while 90°hinges only need to be installed on the fixed panel parallel to the door panel, the cabinet space can be greater use.

One point to note, the cabinet door fixed plate to the cabinet side panel of the inner space clearance > 70mm in order to install 90 °hinges, the door panel buckle the same as the normal hinge.

NO.3 45 ° hinges and 30 ° hinges

45° hinges are commonly used in pentagonal cabinets, when the side panel and cabinet door angle ≥ 135°, use 45° hinges; according to the side panel and cabinet door angle is different, the side panel can be properly adjusted to control the door gap;

30 ° hinges, door panel without cover cover side panel 3mm, side panel do bevel cut processing, door panel from the side panel 2mm gap, side panel can also not bevel cut, but the gap between the door and side panel will reach about 12mm, insects and mosquitoes easy to enter.

NO.4 -45° hinges and -30° hinges

These two special angle hinges are commonly used in triangular cabinets, when 60°> side panel and cabinet door angle ≥ 45°, then use -45° hinges; and when 80°> side panel and cabinet door angle ≥ 60°, then use -30° hinges.

In our lives, with a variety of furniture items, there are some less used to more special hinges today will not do too much to introduce it.

Minzhong special angle hinges, special because you need

Flexible and simple, exquisite and delicate, allowing you to go beyond the conventional, so that special no longer special.

The following is accompanied by some special angle installation display chart: